Accessories
- Printed in very high quality using SLS (Selective Laser Sintering).
- Precise fit, nothing wobbles here.
- To install the display , first connect the display to the board. Then insert the display into the holder and press it carefully and to full width (use both hands).
- Fits the usual "93PR" pots from TT Electronics .
- Made of 6061 aluminum, anodized .
- Radius inside: 13,07 mm, outside: 18,09 mm, height 4,03 mm .
- Pictured potentiometer is not included.
- Fits the usual voltmeters in mod building.
- .
- made of 6061 aluminum, anodized
- .
- outside dimensions: 30 x 18 x 4 mm
- .
- inside dimensions: 25 x 13 x 3 mm Voltmeter shown does not belong to the scope of delivery
- The best MOSFET for mod building.
- Allows the use of any fire button
- .
- Also recommended for high amp fire switches as a safety.
- The required 15K Ohm resistor is also included
- .
- Alternatively with one or two times fuse MHP-TA15-9-72
- .
- This jumps at 75 ° C and opens again when it gets colder
- Only 1/2 inch diameter .
- Made of heat resistant materials .
- An optimal component, not only for box mods .
- Fuse triggers at a temperature of 72°C.
- As soon as the temperature drops below 40°C, it resets automatically.
- The fuse is designed for 15 amps continuous load.
- If more power is needed, simply connect 2 fuses in parallel.
- Five different colors .
- Fine adjustment by mini potentiometer on the back side . .
- Reverse polarity protection .
- 2.4 to 30 volts.
- Four different colors .
- Fine adjustment by mini potentiometer on the back side . .
- Reverse polarity protection .
- 0 to 100 volts .
- Resolution below 10V 0.01, above 10 volts 0.1.